Interested to Buy Any Domain ? << Click Here >> for more details...
carbon-3.23%,manganese-0.60%,silicon-2.25%,sulphur-0.086%,
phosphorus-0.122%,chromium-0.04%,nickel-0.10%,molybdenum-
trace.
- 3 Answers
- 6185 Views
- I also Faced
- E-Mail Answers
Answer Posted / sunil
It is possible to predict the chemical composition of the
Cast Iron based on the Cast Iron Grade. The physical
properties are direct indicators of the chemical compostion.
Si is the element which increases the tensile properties of
Cast Iron. So keeping the Carbon % low and increasing the
Si % will definitely improve the tensile strength of Cast
Iron. Another Alloying element influencing Tensile
properties is Mn. As Mn increases the tensile strength
increases.
| Is This Answer Correct ? | 5 Yes | 0 No |
Post New Answer View All Answers
The requirement for ASTM A217 Gr. WC9 castings for valves components like Body and Bonnet were Normalising at 920+/- 20 Deg. C and Tempring 780+/- 20 Deg. C The specification calls furnace shall be calibtated within +/-14 deg. C The Heat Chart shows minimum temperature for normalising 900 to 920 Deg. C, but maximum temperature 960-990 Deg. C Tempering 780+/-20 Deg. C is within limits and accepted. Casting having integral test bars, heat trated along with castings passed in chemical znalysis and mechanical properties. Since normalising maximum temperature is not meeting specification, where castings can be salvaged or renormalised and retempered to meet specification. Whether it will have affect on remechanical properties testing
A plain carbon steel contains 45 wt% of proeutectoid ferrite. What is its average carbon content in weight percent? I know that you need to use a tie line in the phasediagram, but my book does not really give a good example to go by?
What is the use of core prints?
The Hardness of wheel(or)grade of wheel refers to the
Define what is the metallurgy use? Define what is the casting and forging?
Explain rupture stress
what is wedge load test method . what is offset method .
Define what is meant by hardening ability of metals?
What is hardest cutting tool material?
Which pump is preferred for small discharge at high pressure?
What is lathe bed made of ?
What is a silver in deming drill bit?
What is the use of damper?
Is there a possibility of inducing stress cracking in an insulated stainless road tanker vessel (20 tonne capacity) if the vessel is subject to rapid filling (10 tonne /hr) with liquid methane (-160 c) assuming the vessel is at ambient. If so, where could I obtain suggested cooling rates?
Discuss the otto cycle with diagram.
