Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / suseendran
It is the output voltage drop when transformer is fully
loaded..... This can be measured by conducting short circuit
test.....
| Is This Answer Correct ? | 0 Yes | 2 No |
Post New Answer View All Answers
What about electrical Units. discrive in detail
Match the following a)(X'+Y') b)X'Y' C)XY 1)NAND 2)NOR 3)Carry
1. What is differential relay? How it operates? 2.How to calculate the Short Circuit Impedance in Transformer? 3.What is the alternate solution for testing of polarity by using polarity tester while its milli ammeter does not works? 4. While testing the 33KV Busbar by using Hipot kit, what should be the test voltage we have to apply? 5. What is the procedure/activities to be taken to inject the current more than 2000A by using 2000A Loading Transformer? 6. Explain how you can give the overload setting to any Motor Protection Relay for a HT motors with formula and example? 7. Why restricted earth fault protection is needed? Why can’t differential Protection is sufficient? 8. What should be the minimum and maximum ohmic value for earthing? 9. Why DC Currents are not used in transformer? 10. What is the Frequency while we step up the voltage from 220V to 11KV? Is it possible? Explain it?
please send the last 5 years {{{JUNIOR ENGINEER - ELECTICAL, ELECTRONICS RRB CHENNAI and secundrabad}}} TECHNICAL question papers TO MY EMAIL ID dinesh100701@gmail.com
what is active power & reactive power?
Is there any guideline say about display of earthing value near to earth pit
Which type of air compressor is used now a days in the market. Keeping in mind of energy efficiency and maintenance points. Relevant documents may also be sent on mentioned email ids.
How to calculate total harmonic distortion level(THD) in VFD? and how can we reduce harmonics?
can indirect loading be called as phantom loading?
A 100W electric lamp is supplied from a 115V, 60HZ source. The peak instantaneous power dissipated in the lamp filament is
What are the Return ( Monthly / quarterly/ Annual submitted to Electical Inspector for an establishment (Factory in Maharashtra-- Small scale category having seperate HT line of 22KV ) as per Maharashtra Electricity Act
Where is the best place to mount  distribution panel in a house.
how to calculate fault level?
What is signal flow graph?
how to choose cable size with respect to load? how to convert cable size in mm2 to sq.mm?
