Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / antony
No,Because the response time to blow the fuse is
comparatively very high in HRC fuse.So this may leads to
equipment or device failure.Hence always use/replace a
semiconductor fuse in place of the same.
| Is This Answer Correct ? | 7 Yes | 0 No |
Post New Answer View All Answers
How can we findout the maximum efficiancy of Transformer? At which load?
WHY THE RATINGS OF THE TRANSFORMER IS 33KV WHY NOT OTHER???
In case of salient pole alternator when number of poles are 4 or more than 4 it helps the flux wave to be sinusoid as air gap length is increased from center to tip , but if the number of poles are 2 how does the flux wave is sinusoidal?
3 phase induction motor connection star or delta while using ac drive motor is .75 to 5.5 kw
what is the ms flat constant for calculating earth mat design calculation?
what is the step by step formula for calculating bus bar phase and neutral size of a panel board.suppose the incomer of panel board is 100A..???step by step answer please
why do we not use equivalent voltage source in negative sequence equivalent ckt.
.php|
what is the difference b/w absolute encoder and incremental encoder?
May I know how much values to be set for earth fault, over current and short circuit values at 11kv side? I have 11kv van 1250amps rating. Present it's taking load 80amps?
1. If 8.35%Z means the percentage impedance of 132kV-line from power company, we will like to confirm its base capacity?
work of choke in florocent tube circuit ?
can you send me the placement papers of electrical engg. from companis like NTPC,DRDO,IOCL,HPCL,BPCL etc.?If,plz send as soon as possible.Thanks.
how to design coil turns ?
There are a trformer and an induction machine. Those two have the same supply. For which device the load current will be maximum? And why?
