why the earth pin in a 3-pin socket is longer and thickest?
- 5 Answers
- 7485 Views
- I also Faced
- E-Mail Answers
Answer Posted / rajesh tanwar
The earth pin in the socket is longer so that the phase and
nuetral get disconnected first and earth is disconnected
very last to gave a sufficient protection.
| Is This Answer Correct ? | 8 Yes | 2 No |
Post New Answer View All Answers
can i connect the two phases of scott connected transformer,if not why?
what is difference between line differential and transformer differential?
sail kaott diploma ece ke interviw me qus.kis parkar ke aate hai aur G.S me kya puchate hai kya sameedyaan me kis parkar ke qu.puchate hai
what is alluminium arm in ab conductors
george phenomenon of synchronous machine
what happens when series resonance occurs?
Is there any relevant technique to produce power from light and heat energy of the sun simultaneosly from same rays of light?
A 15 kw squirrel cage motor having a maximum efficiency of 90% on a continuous full load has temperature rise of 42 degrees celcius after 30 min and 52 degrees celcius after 1 hr under the above operation conditions. a) calculate its final steady state temperature rise on continuous load and the heating time constatnt. b) if the motor is operated on a short load for 9 min estimate its temperature rise. c) calculate the maximum overload that can be applied on a short, 9 min rating so that the temperature rise is the same as the final steady state temperature rise on continuous load.
what are the differant std sizes of cable trenches?
WANTCONTACT NUMBER & EMAIL/ WEBSITE TO CONTACT THE SECRETARY,MADHYA PRADESH LICENSING BOARD(ELECTRICAL),K- BLOCK,3RD FLOOR,SATPOODA BHAWAN,BHOPAL
If a transformer primary winding operates at 240v, the secondary at 120v and the load is 1500w & the transformer is rated at 92% efficient, what's the current flowing through the primary winding of the transformer? What is the formula for finding this?
Is there any abbrevation for STUB in Stub bus protection
can you please send me the technical questions and aptitude questions of honeywell and jindal steel electrical engg. question paper my e-mail ID is(kkesavanraj@gmail.com)
rajha power sector details
i have a 4 Mva transformer 34.5 kv / 480-277 v and i used 2 parallel 3200 amp bus duct for the secondary feeder using 3 ply of bus bar ( 3/8" x 5" ) as a common where the flexible link terminated and 6300 amps breaker for the main, the lower bus duct reaches 70 degrees and the upper bus duct reaches 55 degrees when i used thermal scanner. why the temperature is not balance when the load reaches 3600 amps.
