WHY SECONDARY OF CT SHOULD NEVER BE KEPT OPEN CIRCUITED?
Answer Posted / yasmina
CT genarally rated as x/5A,orx/1 A as x value depends upon
full load current, CT Volt amp ( rated VA)is constant on
both primary and secondary ,if you kept open the Secondary
a large value of volatge build up and it is hozordious to
equipment around it and operation people.
| Is This Answer Correct ? | 1 Yes | 0 No |
Post New Answer View All Answers
why impudance relay used for medium transmission power system? why not others?
i want to know d working mechanism of tafe tractors next i like to know d engine type of apache bighs can anyone help me
xfhnchncv?
how a resistor resists to flow the current?how an inductor oppses the sudden change in current?how a capacitor opposes a DC voltage.
State kirchoff current law?
If a shunt Dynamo has induced emf 100V and 0.4 ohm resistance and battery of accumulator of open circuit emf 110V and 0.5 Ohm resistance are in parallel what is common terminal potential difference?
WHY MOSTLY Rph IS USED FOR CONTROL CIRCUITS AUX. SUPPLY ?
The ripple frequency in output of fullwave bridge rectifier is a. Half the input b. Twice the input c. Same as input
what is the Pickup/drop off ratio in BCPU relays
why it is so called as xlpe(cross linked poly ethyline) cable?
what is the formula to calculate voltage drop/loss on 66KV Transmission Line?
Dear all: Recently we got a question about Interface between PMS and SAP-PM.once we got a update message from PMS.we should set the deletional flag for functional location in SAP system.Is there any FM or BAPI to use?There are only functional location create and change provided by SAP. Best regards!
Why a Permanent Magnet Generator has higher frequency as compared to frequency of main alternator?
why power factor is important?
10 tube light connect in mcb breaker.one tube light is fault.so breaker is tribe.how fault is rectified.(using 3wire phase,earth,neutral)