Interested to Buy Any Domain ? << Click Here >> for more details...
Where the excitation is given either stator or rotor in
actually in power plants?
- 8 Answers
- 12251 Views
- I also Faced
- E-Mail Answers
Answer Posted / ankit
in alternators, we recieve power from
stator side. Now rotor contains
electromagnet to generate poles...so that
rotating magnating field generated by
rotor cuts stator winding.. Hence emf is
generated on stator winding..
Now elecromagnet needs supply to
become magnet.. So excitation is given to
rotor.
| Is This Answer Correct ? | 4 Yes | 0 No |
Post New Answer View All Answers
What will be the diameter of pipe between conservation tank and transformer
what material is the electrical housing wire made of? is there any difference for the telephone lines?
In electrical what is earth(ground)connection, wht is the importance of it, why it is recomended to maitain below 3VAC between Neutral and earthspecially in PLC used machines?
how to extend relay operating timing in 24V dc relay card (without using Timer )
Earth leakage relay basic knowledge principle
Is potential difference materials property ..? if yes tnen how.. explain brifly.
what is the difference between interconnection and intraconnections in the circuit diagrams
How do we calculate the resistance per metre of single core aluminium stranded cable 19*3.25mm sheathed in pvc,at 15 deg C temperature?
how line turns ratio changes in 3 phase with change in connection
sir plz send some previous year questions of jspl.
Power factor =1.000 at factory in supply. However, PF = 0.8 at motor end. Current = 100 Amp, Voltage = 400 V. What is the power distribution loss? Can I reduce it by adding capacitor at the load feeder?
What test must you do before powering up a circuit that you have been working on?
How many wall/floor flange will i use in bus duct system if we have in our design a 35th floor building.
how to calculate the mesh earth network resistance in such substation, is there any recommended resistance values with references , thanks!
is there any chart showing the suitable cable size according to AMP and length ? for three phase motors
