Interested to Buy Any Domain ? << Click Here >> for more details...
what is interlock ckt? why it is necessary in industrial
machines ?
- 2 Answers
- 8745 Views
- IOCL, I also Faced
- E-Mail Answers
Answer Posted / sam
Not sure what you refer to with"ckt" but interlocks is all
about starting a application or machine safely.
For example if you want to start up a compressor the
discharge valve must be closed, the recycle valve must be
open, the guide vanes must be at 10%, there must be power
available, there must be air available, the oil must be at
60 degrees, the cooling water recycle pump must be running
and so on. The local control system(PLC) will only allow you
to start the compressor when all these interlocks have been met.
Good luck
| Is This Answer Correct ? | 14 Yes | 2 No |
Post New Answer View All Answers
what is temperature compensation?
How we can check the 2 wire proxy switch? & how it is connected to DI MODULE OF PLC?
steps for installing orifice plate?
What is Erosion in a control valve?
In my company plc based winders are operated. one day there was a data transmission failure alarm shown on pc. as per sir instruction we have reset master plc but winders were not triped and alarm gone. so what master plc do?
how many pulses are required by a ac induction servo motor of 4 poles with 50 Hz frequency to rotate by 1 degree?
we want to control pump in let pressure and tank (for exp) our inlet line if water cam and pump will on and when our tank will full pump will off also if our inlet pressure low pump will off even tank not full.this pump i want to uses on our water supply line.
1.what is controller proportional gain 2.what is the controller intergral action time. 3.A proportional plus derivative controller that has a proportional band of 20% and a derivative action time of 0.1 minutes. Construct the shape of the output waveform for the triangular input if the input rises and falls at the rate of 4 units per minute.
i want to know the interview format fot gail, instrumentation. pls answer me in habib.sami1003@gmail.com
can we replace a slot sensor (inductive type) with limit switch (potenial free contact / no-nc type).
Draw a great bridge circuit.
Why does a pressure gauge installed on reactor, doesn't have any vent line below to release the pressure? Is it any kind of designing mistake or it actually does not require any vent line? And if it does not require any vent line below it then how we are gonna release the pressure built inside the pressure gauge?
what is the advantage of submersible level transmitter compare to ultrasonic level transmitter?
What is the difference between conductive lined pipe and conductive unlined pipe? Why do we see that?
please tell me what is a light up procedure of Cfbc boiler and what it's axuillaries of cfbc boiler?
