Interested to Buy Any Domain ? << Click Here >> for more details...
without a positionar can a control valve operate? give the
difference of operating with positionar and without positionar?
- 5 Answers
- 12168 Views
- IOCL, I also Faced
- E-Mail Answers
Answer Posted / sam
There are applications where the positioner is actually
causing the process to run away, due to the valve reacting
being too fast, and the control will be much easier without
the positioner. You can do this by installing a I/P
converter, piped directly to the actuator.
In 99,99% of applications however, the positioner is
necessary to control the process since process changes is
normally very fast and smooth control will be impossible
without a positioner to speed up the reaction time of the
control valve and keeping the process on the desired control
set-point.
In these applications if you do not install a positioner you
will find that your process runs in a big sinuous wave form
and this will obviously cause a major chain reactions
through out the whole plant.
Good luck
| Is This Answer Correct ? | 10 Yes | 1 No |
Post New Answer View All Answers
what are the documents(Construction point of view for a process plant) submitted by contactor initially entering in to new site for client?
how can i check vortex shedder bar it is ok? if there is ohms condition are shown correct?
Explain PID, ON/OFF, Controls
what is a vortex flow meter,mass flow meter and electromagnetic flow meter.particular use of this.means in which condition particular meter is used.
we are having yokogawa centum cs3000 dcs in our power plant. i need some of the operator guides NOT to appear in HIS0163 AND HIS 0162 but it shoul appear in HIS0164 HOW TO DO IT?
Coal mill Instruments Equipments for cement plant And process diagram ?
what is cold loop? difference between hot and cold loop?
Why is it necessary to use compensation leg to measure the liquid level in a closed or pressurized tank?
How to calibrate H2s Dectector
How hart protocol can be connected with control valves?
1)How many tpes of vibration probe and how many tpyes of vibration. 2)how we can calibrate a vibration probe with tk3 3)what is RMS value in vibration measuring application and how we calculate it.
What is megering????
what is thermo coupler and how it works
Specific gravity.
what is function of sensor, and how is it work , explain with difination
