Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / perwez
when there is a problem with the inventer or when v r are
doing any maintenance that time we bypass the supply, which
means the ups act's as direct supply , if there is power
failure in this case ups will not feed any power.
| Is This Answer Correct ? | 5 Yes | 0 No |
Post New Answer View All Answers
What are the two segments of nyquist contour.
What is a differential amplifier? Also, explain cmrr.
why lightning arrestor are made in two stack of insulator but why not cvt
Can you used moeller lzm1 mccb in a dc system with 125vdc and 20ka short circuit current , beside is it have 24 or 48 volt shunt ? Beside how long current can through from An MCB shunt contacts? (like Z7-AS 24 V)?
I have 440v power coming to facility,( not being used ) can I buy large generator, (gas) to sell power back to electrical co.
how do u gauge the size of the cable ?for eg. consider a 300 sqmm L.T Cable.How do u determine the size of the cable seeing it pratically?
how to size H.T & L.T Panel ?
what is transient enclosure vltage , very fast transients, very fast transient over voltages
Transformer how to maintaince a check b check c check d check
What is kvar?
at meter room 50 hrc switch installed,but there are not get earthing proper,so what happen?and 11kv transformer out put going in to hrc main 400a three nog each? so earthing is require for all switch? (some customer made earthing at there home.)
Is there any specialised book to refer about fault level calculation both in MV and LV side??
What should be the length of transmission line so that we can see/obtain the full sine wave of voltage??
Do any one know exacatly when the results for NHPC held on 8th march 09 for engineering trainees will be released ?. if so please post it, i'm eager to know it.
if we have a industrial load of 400 kilowatts with 415 volt AC then how much total harmonic distortion (thd%) should be acceptable for steady power system.
