why we are caling 440 volt 3 phase supply instead of 660
volt 3 phase supply? because each phase as a voltage of 220
volt. if anybody know the answer for my question please
send it to my mail id. thank you.
Answer Posted / chuck rogers
The sum of any 2 phases is 440. This is a rough estimate as
several factors can play on the load side of the circuit.
Between any one wire (phase) and ground can be 207VAC to
277VAC (with no Load). It's that way because the electrons
said so . . . I talked to them last week.
Is This Answer Correct ? | 6 Yes | 25 No |
Post New Answer View All Answers
What effect does a very low impedance have on the Voltage regulation? On the short-circuit current?
Please tell me the power flow from pmg to main rotor of an alternator (Including AVR unit)?
how the characterstics of control valve being done
Can clean earth cable be considered as low current cable
What happened when voltage will half value of current ...
For a stable system, where should the poles of a system be in a root loci plot?
Application Comparison between 22KV (UE)and 33KV (E) system. Are we allowed to use 33KV (E) cable in lieu of 22KV (UE) cable. What are the technical disadvantages.
hi frds, i m electrical engineer.can i get cdr for electrical engineer if u have then send me on my mail id its jayesh_ee88@yahoo.com.please help me frds
how to produsing geretor power
IN induction motor pf is increased using capacitors.what will be the effect on motor and system when very large capacitor is accidently installed and pf goes leading.
tan delta equation test on alternators
Draw the vector diagram and condition for the following: 1) Dyn1 2) Ynd0 3) YnYn0
mention hazard experienced during installation
How will you justify IR value and Charging voltage of any motor,transformer and Cables.......???? . . . . . . . . Plz tell me any body Baljeet Singh, engineer_89@refiff.com
Explain the iniluencc of short circuit ratio on the pert'orniancc of synchronous machine.