Answer Posted / lim

Inductive VT use conventional magnetic material for
coupling of HV and LV circuit. This method has problems due
to insulation of EHV circuit to the magnetic core(usually
at ground potential) and very expensive to produce as it
may need a few step down stages to achieve to final voltage
ratio, each stage shall be floated at gradually reduced
voltage relative to ground potential.
CVT is design to resolve this cost issue. The voltage is
first step down to relatively low level using capacitor
divider and connect to normal IVT for further reduction in
voltage to final value.

what is the soft starter principle? how is connection diagram? what is the procedure for checking the connection?

2215

---

11000volt DG set carnt kaise banvay

1721

---

1.25 kg of hydrogen are burnt with stiochiometric air, the mass of air in kg required is

2156

---

Haw to check conductivity of budbar

1854

---

Can we check ELCB constantly from R1 to R8 phase in 1 no DB?

1753

---

explain transformer ct connection?

2106

---

To prove the capacity of a 10MVA transforemr with 6.5% impedance by a short circuit test how much power is needed to inject an impedance voltage if we have to arrive for its rated current?

1967

---

how does commutator convert a.c to d.c?

2236

---

which motor have relatively high power factor and what is reason for have high pf? 1.capacitor run motor 2.shaded pole motor 3.capacitor start motor 4.split phase motor

2047

---

how to calculate earth fault relay current and CBCT ratio

8397

---

1. If 8.35%Z means the percentage impedance of 132kV-line from power company, we will like to confirm its base capacity?

2017

---

Dry type transformers

1912

---

WHAT IS THE WORKING PRINCIPLE OF A GENERATER.how is a GTG (Gas TURBANE Generater) working.plz explane

2579

---

What are n circles?

1136

---

which book to refer in electrical engineering for iocl exam & which book for general english.

2285

---