hi this is noor i wnt know the procedure and precations
errection for PRESSURE AND DP transmitters?
how to take impusle line for level and flow?(water and
steam)
impulse line sizes? and type of material ?
plz give me answer / reffer any website ? to me
"mail2noor.hyd@gmail.com"
- 1 Answers
- 3347 Views
- I also Faced
- E-Mail Answers
Answer Posted / anishkumaran.r..nice
Quater inch MS material pipe nd for steam use MS material condensate pot...
| Is This Answer Correct ? | 0 Yes | 3 No |
Post New Answer View All Answers
What is difference between ESD and PLC please Explain me clearly.
How to calibrate radar type level transmitter for interface level? Total liquid(liq.1 and liq.2), level both the liq individually? For. Both the liquid levels how the signal will go from transmitter to dcs? How to calibrate. Single radar 9:26:55 AM for 2 different liquids in a tank?
what is IEC code in cables & how to selecting cables?
Full form of KKS when use DCS.
What is 3 selection available when configure the burnout protection for controller
What is zero elevation and zero suppression?
please tel me the calibration of pneumatic controler.
what is the field bus calble ? what are diffrences in orang colur cable and black coular calble ?
What pressure results for a flow transmitter of range 0- 180t/h in the dcs and 0-301mbar in the field using square root extraction. Kindly also suggest formulae for the percentages 0,25,50,75,100?
Q- Control problem are mainly classified in _____ types. a-)4 b-)3 c-)6 d-)nono of these Few of them i know is 1- regulator type problem (eg- Air conditioner) 2- tracking problem (eg missile trcking problem) 3- sybernatics 4- optimal control problem
what is the difference between magnetic flow meter and mass flowmeter
How does your previous experience relate to the job you are applying for ?
What is heating effect?
can we copy the software from a transmitter using hht(hart 275) ?
Whether the DI, DOs shields can be connected with Analog Input Shield Earthpit?
