Interested to Buy Any Domain ? << Click Here >> for more details...
how does the harmonics enter into the induction motors?
- 1 Answers
- 4120 Views
- I also Faced
- E-Mail Answers
Answer Posted / pavan kumar
in case of slip ring induction motor harmonics occur due to
rotor conductor slots ie., due to non uniform air gap and
also due to improper design
| Is This Answer Correct ? | 7 Yes | 1 No |
Post New Answer View All Answers
What is milivolt dop test in Busducts? What is its significance & procedure to do the test?
where does 22kv line starts
show the single line diagram of star delta starter with single phase preventer
What do you understand by avr?
different aspects of voltage stability
at work i have a genertor/alternater what is the easyest way to work out if it is dc or ac?
which phase is preferred for connecting 1 phase vt used for synchronizing OHL? WHY?
What is cathode ray oscilloscope (cro)?
Hi friends, i m electrical engineer i want a cdr for migration purpose so anybody have information about this then send me on jayesh_ee88@yahoo.com.please try to me
How much costly in percentage wise is sandwich busduct costly than air insulated busduct of any rating?
Explain the function and difference of Restricted earth fault, simple earth fault and sensitive earth fault with connection diagram.
(1)The demand for electricity , the amount of renewable generation available, the amount of fossil fuel generation available and the cost of the fossil fuel generation are shown in table below period(hrs) demand(MW) renewable (MW) fossil- fuel(MW) cost of fossil fuel(MW) 00.00 - 01.00 2000 1800 2000 30 01.00 - 02.00 2300 2500 2000 30 02.00 - 03.00 2500 2700 2100 45 03.00 - 04.00 2900 3100 2100 50 04.00 - 05.00 2700 2600 2500 45 05.00 - 06.00 2400 2000 2700 50 06.00 - 07.00 2200 1800 2000 36 07.00 - 08.00 2100 1600 2000 36 Assuming that the renewable generation incurs zero cost, determine an optimal generation schedule(specifying the amount of renewable generation and fossil fuel generation used in each period, the cost for each period and the overall cost for 8 hours.)
What is the need of earthing transformer for delta side of a transformer. (Think of a line section between a star/delta transformer at a grid substation and delta/star transformer at a village. An earthing transformer is there at the delta side of the star/delta transformer at grid substation). As there are no ground reference there will not be fault current if a one phase is grounded. Further L-L phase will be sensed by the primary side of star/delta transformer as a L-G fault. So why an earthing transformer is required at delta side
is it true there's a big difference in using Cummins or Denyo...especially power output or leakage
application s to shunt coil
