Interested to Buy Any Domain ? << Click Here >> for more details...
What is the difference when selecting a cable between AC
and DC current?
- 13 Answers
- 55055 Views
- ABB, I also Faced
- E-Mail Answers
Answer Posted / awaken
it is always the current rating that is taken care of while
selecting cable since heat produced will have to be
withstand by the cable and stress factor ie the depth below
which the cable has to be layed or the dieelectric strength
between the conductor in case of ac. while in case of dc jus
current and stress factor. ie why conductors are preffered
using same current rating for overhead distr/trans.
| Is This Answer Correct ? | 1 Yes | 7 No |
Post New Answer View All Answers
Why efficiency of generator is higher than motor at a particular load?
during installation time of transformer and alternator which points we have to observed?
What is line resistance of cable & how it can be measured ?
What is difference between Sample test and Routine test in safety standard?
In radial network the source is fed from 1 end both ends at central
why fractional pitch winding generally used in alternators?
what is EIB lighting control system? what is the advantages of this system?
What are the different sign conventions used in electric circuits?
how we can adjust for three phase motor cold stall time ,hot stall time and thermal register set up?
The electrical energy required to raise the tempreture of a given amount water is 200 kwh. If the heat losses are 20%, the energy required is?
How to calculate the electrical load for a standard telecom BTS shelter and choose the DG set capacity for the same load?
how to electrically make connection to ferroli GN2N?
Can you used moeller lzm1 mccb in a dc system with 125vdc and 20ka short circuit current , beside is it have 24 or 48 volt shunt ? Beside how long current can through from An MCB shunt contacts? (like Z7-AS 24 V)?
A 15 kw squirrel cage motor having a maximum efficiency of 90% on a continuous full load has temperature rise of 42 degrees celcius after 30 min and 52 degrees celcius after 1 hr under the above operation conditions. a) calculate its final steady state temperature rise on continuous load and the heating time constatnt. b) if the motor is operated on a short load for 9 min estimate its temperature rise. c) calculate the maximum overload that can be applied on a short, 9 min rating so that the temperature rise is the same as the final steady state temperature rise on continuous load.
Either It Possible a dc Motor to Run On Ac Drive [ Ex : ACS 800 , Yaskawa F7 ] If it is Possible How Pls Inform Me dinesh_elect_eng@yahoo.com
