What is the function of induction motor when low voltage is
apply.
- 6 Answers
- 9275 Views
- I also Faced
- E-Mail Answers
Answer Posted / dilip dixit
WHEN LOW VOLTAGE APPLY TO THE MOTOR THAN TORGUE WILL BE
HIGHER AND FOR THIS SLIP WILL BE INCREASE AND MOTOR WILL BE
TAKING HIGHER CURRENT & BURNT AFTER CERTAIN LEVEL.
| Is This Answer Correct ? | 3 Yes | 5 No |
Post New Answer View All Answers
What is principle of Floroscent tube 36watt.
from which subjects most of the technical que will b asked for hpcl(electrical).pls help me
What is the difference between cylindrical-type and sandwich-type winding?
Q: How to calculate Transformer losses , tell us by Formula.
what is Insulation monitoring device. where it is used? (in switchgear room or control panel or in field equipment)
Can Anyone Answer anyone of these ? Q1) why direct SOLUTION of Load Flow Studies in Not Possile ? Q2)Why majority of Buses in power system are load buses Q3)Why one of the buses in Power system is taken as reference bus (slack or swing) Bus ? Q4)Bus Admittance Matrix is a sparce (means it contains some zero elements ) matrix , give reason
what is proper capacitor placement? How to evaluate capacitor size?
Explain the terms real power, apparent power and reactive power for ac circuits and also the units used.
what may the reason for vector shift in a generator?
How to calculate the size of earth cable to earth the neutral of UPS ?
What test must you do before powering up a circuit that you have been working on?
I would like to know that the fault curretn at base load and at 10% generation will be same? Fault level of BUS remain same with different generation?
armature winding of dc machine produce alternating emf then it convert in to dc by using commutator.But only we consider armature resistance why don't we consider inductive reactane effect?
Please help me regarding my one concern. - During earth pit testing we noticed that the Clean earth pit and dirty earth pit showing continuity (Resistance value - 5ohm) . I want to know that if both earth pit have separate location and there is not internal looping between PIT then why such continuity is showing on it . Because of this issue the field side all earthing point showing short. In PLC panel we are providing two types of earthing cable which is coming from separate earth pit (Clean and Dirty earth pit) because of earth PIT showing short our PLC is not complying spec . please help regarding this issues.
why do we carry out winding resistance test?
