Moving Iron instruments are applicable with
a) DC only b) AC only c) DC & AC
- 14 Answers
- 14940 Views
- Bhel, Engineers India, Engineers India Limited, I also Faced
- E-Mail Answers
Answer Posted / ramanjaneyulu
both ac&dc (c)
| Is This Answer Correct ? | 4 Yes | 1 No |
Post New Answer View All Answers
What are the classifications of oscillators?
WANTCONTACT NUMBER & EMAIL/ WEBSITE TO CONTACT THE SECRETARY,MADHYA PRADESH LICENSING BOARD(ELECTRICAL),K- BLOCK,3RD FLOOR,SATPOODA BHAWAN,BHOPAL
which mm cable should be used for 1.hp immersible pump motor for the distance of 330 metres?
hi friend i am going too attend for hpcl in this month please help me by sending written test question papers i am in the stream of E.E.E
what is meant by star/delta voltages as 440/220 in a 3 phase induction motor, and why it should be connected on STAR IN 3 PHASE SUPPLY
how to calculate transformer load?
Classify milling machines.
can i use 4 number of circuit breaker as single phase manual change over switch? if yes then how plz also send ckt diagram at nazimzamurad@gmail.com
why chock were used in old tubelights but are not newest tubelights?
Why the symbol of register is "zig zag"
how we decide wire gauge for ac or dc coil and what is the basic diff. B/w these two coil?
Is vtg is controlled by the resistor? if else how much?
What are the basic component of a cro?
Can we test the alignment of End shield and stator of turbogenerator without rotor insertion? Also how to fix maintain the alignment at site installation?
what is the difference between switch yard to residential area.and how much required it.
