Answer Posted / ramanjaneyulu
to produce instantaneyosly high voltage i.e 1100v then the
tube will glow the voltage will be redused to 110v
| Is This Answer Correct ? | 1 Yes | 1 No |
Post New Answer View All Answers
There are Two questions about Steam Turbine Generator... What is HRSG bypass of LP, HP used for in power generation? In particualar, in the event that fault of HP bypass, there would be STG TRIP in operation but none on the LP bypass fault...what's the reason ?
Differentiate between voltage and current feedback in amplifiers?
Why space heater is required for each verical bus bar chamber? if one space heater is adequate or not for anti condensation?
which protection used in power plant?
how point on wave controller works.
What do you mean by distribution transformers?
how single phase preventer works ?
How to calculate the copper in HT motors if KW, RPM & Voltage is given
What is the function of the circuit breaker failure relay?
At what factor resistance r of a conductor depends?
give single line diagram of D.G distribution form alternator to main L.T panel?
Briefly define and explain the following different types of Pulse Amplitude Modulation (PAM) with some examples. i) 2-PAM ii) 4-PAM iii) 8-PAM iv) 16-PAM v) Quadrature Amplitude Modulation (QAM)
the typical output of a solar cell is........
why we are using Load factor?
for 100 HP Induction motor service factor is 1.2(SF) we placed a VFD at the motor side load is balance with 0.3 Amp's Phase to Phase but at incoming of VFD load is un-balance with 10 to 20 Amp's what will be cause of load un balance
