Why is the generator rating always in kVA and motor rating
in kW?
Answer Posted / qwde
Aternator's & Xmer's power factor depend on threir loads.
So that u can not calculate KW rating at the time of
manufacturing.
Is This Answer Correct ? | 0 Yes | 5 No |
Post New Answer View All Answers
what is the difference between gas group b and gas group c electrical equipment construction wise?
1.WHAT IS A SMART CAPABLE DB ( DISTRIBUTION BOX) ? 2. HOW TO DECIDE THE TYPE OF DB TO BE USED ( RECESSED/ PLUG TYPE/ SMART ETC ETC? 3. WHAT IS MILLENEUM BUS BAR USED IN DB? 4.DIFFERENTIATE MCCB AND MCB.
how to find 5 kilo meter long under ground 33 kv cable fault location if IR VALUE shows 0.05 M ohm @5000 volt.and cable fault locator shows some time fault distance 3 kilo meter ,3.7 kilo meter and some time 1 kilo meter? now how to find the fault location that where is leakage. note--it is tested with 5000 kv megger and insulation resistance is 0.05 M ohm. and some time 0.03 M ohm comes.
Some times to change of DOR of a motor, interchange of R & B is not effected and RYB take same current, but interchange of R&Y is effected ie change the DOR. My doubt is what is the problem in motor and how it is happen.
how we calculate the short circuit capacity of the busbar in LV & HT?
which cable is used for 15 Hp monoblock pump 3phase and service wire Distance is 210 feet please tell me cable size Armaured
lorteny method
what is the main difference between power devices and signal devices
Sir, plz tell me how droop setting is done in parellel operation od DG set ? please give practical example ?
What are the basic component of a cro?
Please explain, how to test vector group of tranformer(Delta y1) . Thank
what is the major difference between LIBBP & HIBBP.. which one is most preferable..
what type of earthing do for dry fissure rock?
distribution is maximum done by a)radial b)network c) parallel d)b & c
plz tel me syllabus and exam date 4 jr executive engg (electrical)