why we +ve load distribution in 24v and -ve load
distribution in 48volt in the telecom sector.?
- 2 Answers
- 3783 Views
- I also Faced
- E-Mail Answers
Answer Posted / aree dewan
coz in telecom sector ac is always ground wheras dc is used
for battery bank as well as for BTS sector..
| Is This Answer Correct ? | 1 Yes | 3 No |
Post New Answer View All Answers
how to avoid electrical shock how capacitor store charges wat are the speed control of induction motors state faradays law flemings left hand rule what is rotary converter wat is transmission and distribution what are the sources of energy abrevation of acb,vcb,sf6,igbt what is output equation of transformer which test copper iron and iron loss are calculated what is eddy current draw a single line diagram (10 marks) draw direct online starter(10 marks)
How one can check the MAIN of a house wiring ?
What difference between ref protection and differential protection ?
How does a tertiary winding filter harmonic(espcially 3rd one) from entering into load system?
what is diff. between earthing grid,earthing mess, earting grid?
What is the polarization index value ? (Pi value)and simple definition of polarization index ?
battery capacity use of made?
Define ohm’s law for a.c (alternating current)?
What is the difference between AC and DC injection methods for rotor earth fault protection
what is gas turbine intercooling ?
How to address the servo drive for motor
comparision between ACB and VCB
What is NGR . What is the purpose of 10 sec ,60 sec rating of NGR.
I am getting above 60 V as open delta voltage against single phase unit ICT at tertiary delta formed and ICT getting trippped on NDR. ICT tested and found in order. PTs provided on tertiary are tested and in order. what may be the reason?
why asa method ZPF method is more accurate than ASA method?
