Answer Posted / sneha shukla
Harmonics are electric voltages and currents that appear on
the electric power system as a result of certain kinds of
electric loads. Harmonic frequencies in the power grid are
a frequent cause of power quality problems
| Is This Answer Correct ? | 2 Yes | 2 No |
Post New Answer View All Answers
11000volt DG set carnt kaise banvay
In Air circuit breaker LSIG protection unit is used. Without fault in cables (2 runs 3Cx150Sq.mm Copper, 1Kv grade, XPLE armored cable IR value is more than 550Mohm @ 500V Megger) and load section Long time Overcurrent protection is triggers and trips the unit. We changed LSIG protection with new factory tested unit. Even then fault is persisting. Please suggest the possible causes
how we can adjust for three phase motor cold stall time ,hot stall time and thermal register set up?
what is gas turbine intercooling ?
Explain Circuit Breaker Trip Characteristics in detail.
How many capacitors using in LT panel as per Govt rules?
what is earth fault relay 64T, why it is used in main Incomer and neutral CT of Transformer.
Is it possible to protect 3phase overload and earth fault of the 3phase system using two CT's.
What is meant by coupling capacitor?
What is ignition module of a CAT Gas Genset G-3508 Engine, Alternator SR4B Series. HOw its checked for correct functioning.Is it repiarable or replacable?
What is difference between unity power factor wattmeter and upper power factor wattmeter? In short circuit test of transformer the wattmeter used is unity power factor type or upper power factor type wattmeter?
Can 33kva/415v transformer be run underground? If the answer is yes why and if the answer is no why?
How is the resonant peak, resonant frequency, and bandwidth determined from nichols chart?
work of choke in florocent tube circuit ?
What is an alternator impedance value?