Answer Posted / wills
8.937 amps
| Is This Answer Correct ? | 1 Yes | 3 No |
Post New Answer View All Answers
Is vtg is controlled by the resistor? if else how much?
what is the principle of operation of CFL ??
How cable from Kit-Kat to main switch, from starter to motor are designed?
What is knee point voltage of transformer?
What is the lockout relay
-What should be minimum value of insulation resistance and maximum value of earth resistance at any electrical instillation and what is method of testing the same.
how does this job compare with others you have aplied for?
Is there any Electrical supervisor license which gives permit to work whole India rather than individual state??
In Air circuit breaker LSIG protection unit is used. Without fault in cables (2 runs 3Cx150Sq.mm Copper, 1Kv grade, XPLE armored cable IR value is more than 550Mohm @ 500V Megger) and load section Long time Overcurrent protection is triggers and trips the unit. We changed LSIG protection with new factory tested unit. Even then fault is persisting. Please suggest the possible causes
If 22 KV HT line, Current transformer is 25/5 then how to calculate multiplying factor.
In India the supply voltage is 230 volt A.C. During the negative half cycle phase becomes neutral and neutral become phase? or what will happen during negative half cycle? how the electrons flow during positive and negative half cycle?
i have flexible wire. size of conductors is 0.190 mm & no.of conductors are 48. then size of wire comes 1.37 sqmm instead of 1.5 sqmm . the what is tolerance for this size.
What is synchro?
In 11/0.414 KV Parralel supply network with Bus tie closed what will be the fault level is it doubled or halved??
how to calculate the capacitor to maintain power factor?
