Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / mahesh-lanco
bucholz relay is for the protection of transformers for
incipient faults.
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
In siemens S7-300 PLC, what is function and function block ? What is the difference between them ? When to use function and when to use function block ?
how to check regenerative load in drived motor
What is the reason behind current flow(20 A) in amain earth cable of an SMDB? Is cuurent flow(45A etc) through a neutral cable acceptable?
In Dyn11 power transformer if any one of the 3 phases connected to earth in star connected side then please explain effect of the current flow in delta connected side of transformer.(In this case if one phase is shorted to ground in star connected side then we observe the current flow in two phases only not three phases in delta connected primary side. Please explain why it is so?)
How to calculate ant test the burden of Current transformer
is IS says that neutral should be brought to switch box. and this one is a recomended practice
A 2083kva AVR was tested, phase to ground shows continuity, what is the implications
for 100 HP Induction motor service factor is 1.2(SF) we placed a VFD at the motor side load is balance with 0.3 Amp's Phase to Phase but at incoming of VFD load is un-balance with 10 to 20 Amp's what will be cause of load un balance
new 90kw motor installed so how I purchased cable ,fuse,etc please give me technic for cable selected why always capacitor delta connection
what are problems caused by the pdu in rack server
Why does the speed regulating system adopting I controller have no steady-state error? In this single closed-loop speed regulating system, when the input of the I controller Un=0, what is the output voltage of the regulator? What factors do the output voltage depend on?
how to i get B licence,i am completed BE electircal and electronics engineering.i want to konw the proceduure to get b licence
What are merits & De-merits of State-Space Method? What is series programming, parallel programming, general programming & direct programming ? And, difference between these programmings Techniques ?
HOW TO CALCULATE THE REGULATION OF 100 AND 25 KVA TRANSFORMER
Mention the disadvantages of low power factor? How can it be improved?
