Interested to Buy Any Domain ? << Click Here >> for more details...
What are the differents between Breaker & Contactor?
- 8 Answers
- 62831 Views
- I also Faced
- E-Mail Answers
Answer Posted / rajesh ku sahu
Basic difference between circuit breaker and contractor is
That, A circuit breaker can make, break and carry current
in all conditions i.e normal, overload and short circuit.
It will protect the system from over load, Earth fault &
unbalance as well as it has different load & trip setting
and it don’t want any fuse back up. That was not inbuilt in
contactor. A contractor can make, break and carry only in
normal and overloaded condition not in short circuit
condition. Also, Contractor are always backup by HRC fuse
where as there is no need of any backup in circuit breaker.
For frequent operation, contractor is more efficient than
the Circuit breaker.
| Is This Answer Correct ? | 5 Yes | 2 No |
Post New Answer View All Answers
what is formula to cal cute earth pit numbers and size of earth strip used in earthing?
what is the use of sdf?
What is the difference between earthing,ground&nutral?
What is speed mode?
how can service sitting be setted for MCCB?Example for sittings IR (CURRENT RATING),IS(CURRENT STARTING) I O (current operating)?
Mention the disadvantages of low power factor?
WHAT IS IEC? & WHAT IS BENEFIT TO PRODUCT FROM IEC?
What should be the length of transmission line so that we can see/obtain the full sine wave of voltage??
For R-L or R-C ckt,time constant formula is L/R and RC respectively and its unit is in sec.Pls tell me the derivation
what should be the no load current for 3 phase ac motors ranging from 5 kw to 1000kw?
How to calculat the ratio of HT\LT in energy meter
What is electrical grounding?
what is submersible pump?what is different between motor and sub motor?
In Air circuit breaker LSIG protection unit is used. Without fault in cables (2 runs 3Cx150Sq.mm Copper, 1Kv grade, XPLE armored cable IR value is more than 550Mohm @ 500V Megger) and load section Long time Overcurrent protection is triggers and trips the unit. We changed LSIG protection with new factory tested unit. Even then fault is persisting. Please suggest the possible causes
I am B.E.electrical engineer having 7 years of experience in Transformer testing upto 315 MVA.I want to khow how I can get the 'Electrical Valuer' License.
