Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / desingurajan ramco cements...
Fuse not having low melting point..... it is always having small thickness when compare to wherever it is connecting in the conductor.... CURRENT MEANS FLOW OF ELECTRONS...... when any faults occurs (like, short circuit..etc) more electrons flow through the fuse compare to normal running condition. that time more electrons not able to flow through the small area(ie fuse). at the time fuse will be over heated. and it will melt. and proper fuse wire having aprox 800C. melting speed is based upon the fault level......
| Is This Answer Correct ? | 2 Yes | 1 No |
Post New Answer View All Answers
What is evaporator & condencer & compressor
why need to be maintain power factor for industrial customer?
1600 KVA ka transformer hi aghar lt side par 800A aur voltage 420 ho to HT side ki cable ki rating keya ho gi?
What will happened if the neutral of the (star connected secondry) Xformer disconnected? (if its Above KVA rated one)
what is the generator rating for 40 amp load of 3phase motor.?? 400v voltage of generator... plz tell me with formula its urgent...plzzz... and also tell me that this 40 amp at all phases mean 40 amp on red,40 amp on yellow,40 amp on blue...... or the total sum of that 3phase is 40 amp....
What will be the effect of circulating current in HT xlpe cable when both the armour ends are grounded. Will the termination fils after some time in case of 33 kv supply.
How many types of oil using in H/T & L/T Oil Circuit Breakers. need Explenation ?
what ispositive, negative, zero sequence impedence?
What is the dependency of stiffness on load angle??
what is the maximum permissible limit value of leakage current and leakage counter reading to replace lightining arrester?
1) What are your personal strength? 2) What are your personal areas of improvement? 3) What are your expectations from from a particular job? 4) what are your carrier objectives?
What is mean by hot and cold loop testing? What is the difference between them?
how to control dc motor?
We have 750KVA DG set, we want to introduce REF relay with 1250/1A,CL PS,Current transformers.The lead distance of 2.5mm copper flexible cable from CT to relay is around 5mtrs.We would like to know the knee point votage(VK) & IM calculion for CT's
What does the term “voltage regulation” means?
