Why I-section is preferred to channel section?
- 7 Answers
- 17329 Views
- Engineers India, I also Faced
- E-Mail Answers
Answer Posted / a.k.mishra
AS MENTIONED MOI IS ONE OF REASON .ALSO WE WILL REDUCE THE
WEIGHT OF CONCRE AS WELL AS RIGIDITY..........
| Is This Answer Correct ? | 2 Yes | 1 No |
Post New Answer View All Answers
What is passive earth pressure ?
What is reinforced concrete?
What is the general specifications of a bituminous pavement road?
Can you pl explain the procedure steps of singly and doubly reinforced beams in limit state method
density of crush sand & crush stone or grit powder
Why should pumping be not used in case of concreting work?
Required concret Surface Temperature prior to coating of epoxy pain with references ASTM or ACI whatever
Explain major differences between routing maintenance and major maintenance.
Sir, Iam Applied in rrb for the posts of Junior Engineer.I want to know about the or question previews to study well.Pl send it to shukla_varun1985@yahoo.com.
1.Fe500 and Fe550 having more yield strength than Fe415.But why are we prefering Fe415.? 2. d^2/162 formula for knowing the steel wt/m apply all these three? Thanks.
find the discharge of water through a horizental venturimeter having 400mm dia at the inlet main and 150mm dia at thorat.if the diffrential gauge between inlet and thorat shows a pressure head of 25cm mercury. assume coefficient discharge 0.98 and specfic gravity of mercury as 13.6.
how do you calaculate the total steel quantity of an rcc building using thumb rule?
How foundation is designed, Column design and beam design
what is density of 20mm coarse aggregate.plz send answer my below adress e.mail
is concealed wiring a problem in fly ash brick wall?
