why relative humidity is different in different places
Answer Posted / murthy
relative humidity is relative measure of humid conditions
to that saturated humidity,so it varies with location it is
measured, because variation of saturated humidity.for eg
near sea there will be higher relative humidity , where as
in desert areas lower relative humidities
Is This Answer Correct ? | 9 Yes | 6 No |
Post New Answer View All Answers
Are some heat transfer services more prone to tube vibration that others for a shell and tube exchanger?
What are the uses of quicklime?
What are the apt definitions for apparent power, active power and reactive power? Explain about different types of lamps?
Explain the use of gear pumps in motor?
Repected sir/Madam, I am goingb to face IOCL technical as well as HR interview, can you forward your hellpfull hand for toward me to sort out my problem by giving some imp interview quetion which is generally asked in chemical industries such like IOCL,HPCL,ONGC,BPCL,RIL,etc I will always thankfull to you,for sharing your profficient knowledge with me and making me somewhat technically sound
How are vessel lined with glass or how are they coated?
Why is double the amount of gas collected in one of the test tubes in electrolysis of water than th amount collected in the other? Name this gas?
Why whenever a reciprocating compressor is switched ON or OFF it is put into unloading mode?
Why is a vacuum breaker used on shell and tube heat exchangers that are utilizing steam as the heating utility?
How does a tank-blanketing valve operate?
What is the wet bulb globe temperature (wbgt)?
What is a good method of steam tracing large vessels?
Explain why is post-weld heat treatment (stress relieving) sometimes necessary for welded vessels?
any meter avilable for measureing the Transformer Losses. ( like Voltmeter for voltage & ammiter for currenr )if yes plz give the make & supplier address, Email, Phone number.
if i added hypo before DM plant so i will affect my resins of anion or cation. if affect it so do prevent what kind of step should be taken to remove hypo before DM inlet?