Interested to Buy Any Domain ? << Click Here >> for more details...
IN ALLEN BREADLY PLC FAMILY RS LOGIX 5000 USING WHICH
PROTOCOL?
- 2 Answers
- 7394 Views
- ABG Shipyard, I also Faced
- E-Mail Answers
Answer Posted / manickam.kc
DF1 protocol is an Allen-Bradley data-link layer protocol
that combines .... Softlogix 5800 provides virtual PLC
control using a PC and RSLogix 5000. ...
The DF-1 protocol is an asynchronous byte-oriented protocol
that is used to communicate with most Allen-Bradley RS-232
interface modules. More specifically, the DF-1 serial frame
composition is that of a conventional RS-232 serial frame,
where DF-1 forces some of the serial parameters such as 8
data bits, no parity, and a maximum baud rate of 19200.
Further, the DF-1 protocol specifies how to send data
through a conventional RS-232 serial port, in order to
communicate with the corresponding Allen-Bradley products.
| Is This Answer Correct ? | 4 Yes | 1 No |
Post New Answer View All Answers
How do I stop pid 4 from using port 80?
Does ip address change with wifi?
Why is smb used?
How do you check if a port is blocked?
at which layer of osi model does segmentation of a data stream happen?
What happens from the point an HTTP request is received on a TCP/IP port up until the Page fires the On_Load event?
How do I get computer name from ip address?
What is synchronization os?
What is routing protocol and its purposes?
Is a form of interprocess communication?
What are the services provided by Session layer?
What is subneting?
How do I know if my ftp port 21 is blocked?
How does tcp try to avoid network meltdown?
How do process communicate?
