If R and Y terminals are short circuited,then power will
cut. we all know that power cannot be stored.what will
happen to already generated power at power station?
- 3 Answers
- 4730 Views
- I also Faced
- E-Mail Answers
Answer Posted / senthil
SHORT CIRCUIT MEANS CURRENT HIGH .IT DAMAGE THE EQUIMENT
| Is This Answer Correct ? | 3 Yes | 0 No |
Post New Answer View All Answers
if 6 earth pit value is 1.5 ohm then what should be the number of earth pit to make the value .8 ohm
In case of HV test on medium voltage cables, BS is asking for 4 U0 where as IEC is asking for 3.5 U0. Can any one advise me how this 3.5 times or 4 times U0 is derived?
how we can calcultae the short circuit level for bus bar
how to select the automotive wire size by mathematical calculation. for xenon headlamp with ballast. the ballast given data voltage 10-17v,current permenant 6amp, run up phase is 15amp, peak at swicth on max 400micro sec is 40amp.the sum of cable resistance is 150mohm.please provide referenc document if any for relating the peak at switch on current,time & wire wire size
What the difference between three phase contactor (coil 110vac) & three phase SSR (control voltage 110Vac)? May I use contactor in place of SSR?
Is it good to short Neutral and Ground in the PLC or DCS main Power supply. Pls give YES or NO with reasons...? Simarpreet
How to select batteries required for ups and the inverter if we Known load? And how AH is selected of battery?
hello friend i wish to study a course related to the electrical construction, controlling and monitoring , which course i want to study? pls give me the name of institute?
state basic meaning of 'INDUSTIAL AUTOMATION'?
When are the directional relays used?
WHAT HAPPENED DC SERIES MOTOR FIELD WINDING OPEN. CAN POSSIBLE.
During Testing of Maintenance Free Earthing, How deep should be the Spikes of Earth Test Meter should be inserted in the soil(one spike is 15 Meter & Other spike is 30 Mtrs away from the Main Earth Electrode. Because, recently, we observed that when spike is inserted 3-4 Inch in the earth- results are better, If spike is inserted 1 feet deep than results are increasing.
how to calculate cable size in diffrent loads?
how to select diiferent power transformers of same capacity on no load loss and full load loss by economical point of view.?
What is difference is of VSD,VFD,VSDS, are they the same as the direct current to control dc using above mention
