Interested to Buy Any Domain ? << Click Here >> for more details...
what is the frequency standard with tolerance level for India?
- 16 Answers
- 27686 Views
- I also Faced
- E-Mail Answers
Answer Posted / nagarjun
50hz paka
| Is This Answer Correct ? | 0 Yes | 1 No |
Post New Answer View All Answers
we have two generators different capacity on 15 MW and other 6MW at 11 KV , 15 MW gen. bus short level current 40KA,and 6MW short level current 25KA,, length of cable 100MTR between 6 MW from 15MW gen. for bus coupling . kindly tell any one can we use both NGR OR one NGR from any GEN. BOTH NGR has diff. rating. Tariq pakistan
is there any phase difference occurs while primary and secondary side mutual induction occurs?
WHAT IS AIR GAP VALUE IN MM FOR A 11KV BUSHING OF 11KV/440V DISTRIBUTION TRANSFORMER. AND AIR GAP VALUE OF 25 KV BUSHING OF AT TRANSFORMER OF 25 KV TRACTION. WHAT IS THE CALCULATION FOR THE AIR GAP PERMITTED FOR BUSHINGS AT DIFFERENT VOLTAGES.
how can we change the phase angle b/w two phase?
Why choke coil is connected in series with starter in tubelight??why starter is connected in parallel to tubelight??
What is A check, B check, C Check & D check for a diesel Generat
How phase displacement change in the over current relay coils.
battery capacity use of made?
The Howland current source produces a A Unidirectional floating load current B Bidirectional single-ended load current C Unidirectional single-ended load current D Bidirectional floating load current
What should be the length of transmission line so that we can see/obtain the full sine wave of voltage??
I need to connect a synchronous generator to the grid using automatic synchronization and two circuit breakers (one for synchronization, one for end connection to the grid), how to determinate the required diameter of the cables?
if 6 earth pit value is 1.5 ohm then what should be the number of earth pit to make the value .8 ohm
why various test are performed on electrical panels & power cables before commissioning on site & what are these test???
how to calculate maximum current
what is the calculation involved to design the heater to heat 10KL of water in temperature control unit?
