Interested to Buy Any Domain ? << Click Here >> for more details...
If R and Y terminals are short circuited,then power will
cut. we all know that power cannot be stored.what will
happen to already generated power at power station?
- 3 Answers
- 6092 Views
- I also Faced
- E-Mail Answers
Answer Posted / guru
The Generator runs on less load (Means Less current) and
the power is not generated to its full capacity.
| Is This Answer Correct ? | 1 Yes | 2 No |
Post New Answer View All Answers
Different STANDARDS (BS, IS, IEC etc) gives different informations on CT specification. How they correspons w r t each other (i.e I mean to say BS provides "knee point voltage" but IS does not, then how can i select CT)
What will happened if the neutral of secondary of Xformer ( Star point) Note it's above KVA rated Xformer
what is the use of piston rings in the engine used for a generator...........
he compression ratio for a petrol engine generally lies between
Load transfer in 11kv double busbar switchgear - operation.
I HAVE A 50A MCCB AS PER DESIGN LINE WIRE CONNECT UPWORD SIDE AND LOAD IS CONNECTED TO DOWNWARD SIDE TO THE MCCB.IF NOW ANY ONE CHANGE SUPPLY & LOAD(WISEVERSA) WHAT HAPPENS ? DOES MCCB OPERATION OR WORKING FUNCTION NORMAL IF YES THAN WHY THERE ARE MARKED LINE & LOAD ON MCCB.
why we dont prefer ac voltage controller instead dimmerstat [if both have same rating] for conducting experiments in laboratories?
Explain cos(theta) and Sin(theta)
In what cases (circumstances)we should apply P controller, PD controller, PI controller & PID controller ?
diff b/w elcb and rccb
What are the different sign conventions used in electric circuits?
During Testing of Maintenance Free Earthing, How deep should be the Spikes of Earth Test Meter should be inserted in the soil(one spike is 15 Meter & Other spike is 30 Mtrs away from the Main Earth Electrode. Because, recently, we observed that when spike is inserted 3-4 Inch in the earth- results are better, If spike is inserted 1 feet deep than results are increasing.
what is the maximum permissible limit value of leakage current and leakage counter reading to replace lightining arrester?
what is harmonics? what are the factors it will depend upon
What should be the percentage increase in length of the dead end clamp for bus bar conductor (Hawthorn) after hydraulic pressing and what should be the applied pressure?
