how to calculate the cable size for LT and HT power cables
with detail explanation?
- 2 Answers
- 14135 Views
- Asset Developments, Bhel, I also Faced
- E-Mail Answers
Answer Posted / m raviteja
depends upon the rating of a motor or feeder. for LT the
current capacity of power cables for AL is 1.5 times of
cable size and copper is 2.5 times.
| Is This Answer Correct ? | 18 Yes | 11 No |
Post New Answer View All Answers
In Power Line Communication (PLC) the wave trap is used to block communication signals from entering neighboring lines. My question is this: Why do they allow for different filtering arrangements on these wave traps? Isn't it always going to be a low pass filter since we want the power frequency to go through, and the comm signal blocked?
how to select proper cable for ct wiring so that drop within the limit.
how to decide no of electrodes for 1600A LT Main incomer panel
What is CVT and what is relation with wave trap?
what is charger supervision and control supervision?
i have total 8 dg sets for synchronizing and 2 buscoupler,1 sectoin dg no 1,2,3,and 2 sectoin dg no 4,5,6,and last section dg no 7,8 ....if buscupler no 1 and 2 is off mode ..than dg no 1,2,3,will synchroniz of another dg sets?
from generating station If 400v LT line length is 1000m how much voltage is drop and how do i calculate it? which cable will be use for this line?
Where I can get the sample question for post of Junior engineer electrical-II For RRB Bhubaneswar.
Why Neutral Isolation is required?
What are the advantages of a three-phase system over a single-phase system?
how to design the heater in temperature control unit to heat 50KL of water?
if i am in front of transmission line how to know that current direction without any equipment
what is transient voltage?
What is the formula for calculating the Instantaneous Short Circuit & overcurrent for any breaker
Is a 300w induction motor used in a food processor as powerful as a 1000w DC motor.
