what happens if number of poles in stator and rotor windins
of slip ring induction motor are not same. Will it rotate
near to the synchronus speed defined by stator?
Answer Posted / guru
The Speed of the SLIP RING Induction motor is defined by
its no. of poles available in the Stator only. The rotor
windings are used to avoid a high starting current(Like in
Squirrel Cage Induction Motor) ( Thats why rotor resistance
starter are used in SLIP RING INDUCTION motors and also to
increase the torque.
gurusnathan@gmail.com
| Is This Answer Correct ? | 3 Yes | 1 No |
Post New Answer View All Answers
What is the different between conventional MCC and intelligent MCC? Common controller or controller for each bucket
Explain the function and difference of Restricted earth fault, simple earth fault and sensitive earth fault with connection diagram.
What is the maximum number of swithes that can be connected in series up to down stream point in an LV Distribution system?
What does the term power factor shows?
i karmveer bharti persuing b.tech . plz send me syllabus and name of reference books. for preparation of section eng.
I PURCHASED A DEISEL GENARATOR SET OF AVR TYPE& RATING 125KVA BUT SOME TIMES THE OUTPUT VOLTAGE IS FLUCTUATING WHAT ARE THE PROBABLE REASONS GIVE ME
how to compute kvar in substation feeder to improve power factor and sending voltage
Can we use BS 6651 and BS EN 62305 standards for computer room lightning ptotection in substation?
why would amp draw on neutral wire be as much as amp draw on the hot leg.
what is Fan Control Cubicle
How do you determine the size of transformer radiators in a transformer?
State ohm’s law?
how will reduce the voltage. if 12volt/250ma transformer toreduce 6 volt
What is the alternate solution for testing of polarity by using polarity tester while its milli ammeter does not works?
What is the RMS and DFT principle of analogue maesurments. Which way they are advangages. where which princples give optimum results.