what is the function of anti-pumping in circuit breaker?
Answer Posted / sangeetha.np
The circuit breaker can be operated from panel, if they are
simulated it can be operated from computer, and in the
local mode also, this anti pumping provides protection
against multiple closing of breaker. Once the breaker is
closed in any of these modes it wont accept it another
time,as it can be operated in many ways.
| Is This Answer Correct ? | 20 Yes | 8 No |
Post New Answer View All Answers
what is the isolation transformer. what is the isolator?
hey guys i scored 910 on GRE and 67 on TOEFL respectively.I have an aggregate of about 74%in my B tech.For which colleges should i apply for an MS program in electrical engineering.I am looking for colleges in NJ,SC,NC,GEORGIA, NY. Please reply with a good response.....
Define active and passive network?
how braking & making capacity of circuit breaker are calculated?
What are motor generator sets and explain the different ways the motor generator set can be used ?
if flux and load static in dc motor and supply voltage increases 20% then what happened in speed
write down the formula of cable size in RM if current is 50Amp.
WHY IS THE EARTH FAULT CURRENT ALWAYS LESS THAN THE NORMAL CURRENT??
Give some differences between open loop and closed loop?
what are the pecularity of shaver sockets ?
what will happens if one phase is missing for 33/11kv power transfomer and why?
how we explain parallel paths armature winding?
Is the installation of the filter cloths necessary before spreading the gravels at the transformer yards?
what happens to the water pump if ground water level is slowly decreasing?our water pump is varying from no-load full-load due to this problem
WE ARE PLACE A NEW 75 KW MOTOR FOR JPF.IT IS CONNECTED IN M.C.C. WHEN WE ARE STARTING M.C.C.INCOMER IS TRIPPED.THEN WE ARE CONNECTED IN P.C.C WITH A MM30 RELAY PROTECTION THEN WE ARE STARTED MOTOR WILL RUN SMOOTHLY.