Interested to Buy Any Domain ? << Click Here >> for more details...
i have one tank of 500mm height, which is in under vacuum of
735 mmHg, I want measure level of the same using DPT , SO WHAT
WILL BE THE URV & LRV, DENSITY OF THE TANK FLUID IS 0.95. is
there necessary to fill the LP side with fluid.
- 7 Answers
- 17040 Views
- I also Faced
- E-Mail Answers
Answer Posted / sam
Have to agree with Naman that this is not the best way to do
it and there are other devices that will work better if the
current instillation can be modified to accommodate a
different type of instrument like a capillary type of DP Tx
or a level troll.
According to question, the DPT is already in place and needs
to be used so above is the way to do it, and yes it is
possible to do since I have done it myself on a d-aerator
column under constant 0,98Bar vacuum and a span of only
300mm. My situation was the same in that I could not just
modify the installation and had to work with what was
installed.
Keep in mind that once the wet leg is filled the vacuum is
pulling against a closed end. Test this the next time you
drink a Coke out of a can . Suck the straw full and close
the end with your finger and try and suck the Coke
out.(please use a metal tube and not a plastic straw, LOL)
Good luck
| Is This Answer Correct ? | 9 Yes | 0 No |
Post New Answer View All Answers
What is stripper & spilitter ? Diffrence in this.?
draw the block diagram of a level transmitter ?
how will you check torque value during Factory acceptance Test for control valve/ESD ON/OFF VALE how will you confirm this torque value is being correct, Which document will you be refer.
NSV type probe stands for
how to calculate range of level transmitter?
What inherent design and operating principles are included in a modern control system to use predictive maintenance practices to increase overall system reliability?
In control valve proximity inductive sensor is taken as digital feedback for full open and full close.Normally its volts 24v when the sensor acts the feed back voltage 14v so that our relay not indicating in plc panel . kindly give the solution.
DEAR SIR/MADAM MY NAME IS ARKAPROVA BHATTACHARYYA.I AM A FRESHER INSTRUMENTATION ENGINEER.CAN YOU PLEASE SEND SOME QUESTION PAPERS OF GRADUATE ENGINEER TRAINEE EXAM OF DVC(DAMODAR VALLY CORPORATION).MY EMAIL IDs ARE arka_aec@rediffmail.com.
basic connection and principle of axial shift sensor n differential sensors in tubine describes n draw......
Isometric drawings are generated during _________________ phase of a project
when the instrument tapping on pipe line is located below and transmitter is located above the tapping point for liquid service transmitter, what should we do, is there any additional drain valve is required??
while am calibrating Drager polytron 2IR flame gas detector occured non zero status.how can i get zero status?
How to Calibrate Temperature Switch in field
How addressable fire systems work? Pl. send details with architect.(Loop), also send details regarding Gas system. Pl. help me.Thanks
i am from instrument branch i want paper patern of mahagenco . any pevious years paper regarding my branch send me please . please.....
