Answer Posted / abdul rawoof
CBR:California Bearing Ratio Test is done for determining
the bearing capacity of the different types of the soils in
different compositions through the CBR test and design the
appropriate pavement for the given conditions depending upon
the drained and undrained CBR values.
| Is This Answer Correct ? | 7 Yes | 9 No |
Post New Answer View All Answers
What is the cost of shuttering per Sqm.? How it is calculate by thumb rule...?
Define What is a projection line?
important question on stones
what is meant by shear center?????
List out some of the software used in the construction sector to estimate cost and monitoring expenses?
How foundation is designed, Column design and beam design
What is difference between combin footing & rapt footing
What are your goals?
How do we determine the specific gravity of a cement?
Explain the different types of building contracts?
A doubly reinforced concrete beam is 25 cm wide and 50cm deep to the centre of tension reinforcement. The centre of compression is steel is 5cm from the compression edge. The areas of the compression and the tension steel are 10.16cm2 and 12.56 cm2 if m=18 and the bending moment at the section is 7,000,000 N-cm. Calculate the stress in concrete and steel.
WHAT IS THE MAIN DIFFERENCE B/W HIGHWAYS AND MOTERWAYS?
CAST EFFECTIVE WATER SUMP CONSTRUCTION DETAIL
need to join coaching institute in coimbatore tamilnadu ......say me the best coaching for IAS
what is high type road and low type roads
