Identify the 2 commands that display the clock rate
configured on
the serial0 interface?
A.) show serial0
B.) show interface serial0
C.) show clock rate serial 0
D.) show controllers serial 0
E.) show running-config
- 5 Answers
- 8476 Views
- I also Faced
- E-Mail Answers
Answer Posted / guest
B is incorrect for 2 reasons- firstly the command is show
interfaces...not interface, and secondly it does not give
info on the clockrate.
D and E are the correct answers that list clockrate within
the outputs.
| Is This Answer Correct ? | 1 Yes | 0 No |
Post New Answer View All Answers
Hi Friend. i have to let you know that now i have been selected for cisco india in bangalore. i am thanking to all of you guys that u have been posted such good question and the respective answer. from today i will be not able to visit this site on regular basic and hopeing that you will continue to post the question.the question you are posting is not very usefull to you but also usefull to another. i am again thanking to all of you and hope for best for your feature. Jitendera kumar sinha Network engineer-L2 cisco india Bangalore
What are some standards supported by the Presentation layer?
What is matric?
Why subnetting is used?
What are 10base5 ethernet lans?
What is the working of router?
Explain how many tables are in ospf protocol?
Name the 2 protocols are in wan technology?
On which interface we always apply access-list?
In which protocol supenetting is enable by default?
Explain what are partial updates?
What is de-encapsulation?
Define the multicast routing?
In which protocol you manually enable route summarization?
What is half duplex and full duplex?
