Interested to Buy Any Domain ? << Click Here >> for more details...
what is the role of id fan in a furnace?
- 3 Answers
- 11432 Views
- Essar, JSW, I also Faced
- E-Mail Answers
Answer Posted / mm
Id fan maintains the pressure equillibrium inside the
furnace by providing slightly negative pressure inside the
furnace, so that the gases are let out of the furnace to
the chimney. If the chimney height is more, it may not be
adequate to evacuate the gases in the furnace. Hence Id fan
acts as a booster to maintain draft in the furnace, though
some may be of the opinion that Id fan acts as a sucker of
the gases generated in the furnace thus avoiding explosive
gases to be let into the environment.
| Is This Answer Correct ? | 14 Yes | 0 No |
Post New Answer View All Answers
how much maximum power can be generated by 320v, 10kg-cm synchronus motor if shaft is roteted mechanically at 50 to 60 rpm?
Explain how are vessel lined with glass or how are they coated?
DEAR SIR, IS IT ANY BARC TECHNICAL OR INTERVIEW QUESTION BOOK IN CHEMICAL ENGG LAST YEARS IN MARKET? ALSO GIVE THE PATTERN HOW TO PREPARE AND WHAT TYPE OF QUESTION THEY ASKED?
What are the frequently asked technical questions in chemical engineering during PI?
What is the difference between cfm (cubic feet per minute) and scfm (standard cubic feet per minute)?
Under what circumstances are vortex flowmeters the most accurate?
How can you determine the largest impeller that a pump can handle?
Explain the difference between cfm (cubic feet per minute) and scfm (standard cubic feet per minute)?
The job profile as a Service Engineer?
Mention some of the specialized crushing methods?
Are there any special considerations to be taken into account for combusting ammonia?
white rust formation over zinc plated and yellow passivated fasteners during CED painting. WHY?
any meter avilable for measureing the Transformer Losses. ( like Voltmeter for voltage & ammiter for currenr )if yes plz give the make & supplier address, Email, Phone number.
How to size the cooling tower sump / basin for any given circulation rate? What is the guideline?
What is the practical particle size limit for pneumatic conveying?
