Interested to Buy Any Domain ? << Click Here >> for more details...
How many types of relay are present in a VCB and ACB, what
are the tests we can conduct on both breakers and how to
set the relays values
- 2 Answers
- 47786 Views
- Hyundai, Sodexo, I also Faced
- E-Mail Answers
Answer Posted / vijaykumar
Protection of the feeders depends upon the load but not on
the type of breaker used.
VCB-measure the Contact resistance and breaking
resistance,tripping time other mechanical interlockings for
the breaker Mechanisms.
ACB-Check the contact reisitance and the contact tips which
are visible to naked eyes,arching chutes,since air is the
quenching media.
| Is This Answer Correct ? | 12 Yes | 5 No |
Post New Answer View All Answers
When a single pase capacitor run motor- run on 230vac and Case(1)run with 8 Mfd 250 vac.capacitor , Case( 2) run with 8 Mfd 400vac capacitor. What is difference between both case regarding power ,efficiency etc?
How do you calculate the actual power consumption of an inductive load appliance. Say, a deep freezer of 200watts
What is the type of feedback used in an op- amp schmitt trigger?
what is subtransient , transient and steady stateac components
If I want to connect a capacitor bank on the HT side of a 11kV/415V, 3 phase delta-star distribution transformer to supply Reactive power to it..what practical specifications of a Capacitor bank that can i've??please reply..
What do you mean by dependent and independent voltage sources?
how can i find ct ratio of meter by seeing name plate of meter and how it should be used in MF calculation if it shows only-/1???
list the type of vfd? wich is sutable for heating kiln?
we have 3 single phase transformers. how will we generate 6 supply from 3 phase supply input
Difference between drift current and diffusion current?
Dear all, how we select the cable size according to current with or without including different correction factor , is there any direct method for sizing of cable...
can a 150 kva 3 phase 440v/230V delta-wye step down transformer can be use as step up transfoermer with connected loads at 440v side?
What was your role in the silicon evaluation/product ramp? What tools did you use?
The knee point of a current transformer is normally unique and known.So why in the nameplate of a CT they put the minimum value like this Vk> 400v.
what is inter connected dc generator?
