Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / sumit kumar
the knee point of voltage of ct is the that point at which
cts enters into saturation state.
| Is This Answer Correct ? | 9 Yes | 0 No |
Post New Answer View All Answers
What fomula is used to calculate: 1. rated frequency withstand voltage, and 2. rated lightning impulse withstand voltage.
how we do Vector group ,magnetic balance and tap changer test in Transformer?
why co incidence factor considered in transformer sizing?
how to calculate the no load current in transformer?
1.what is the difference between transformer differential and busbar differential.2)why we are using 2 slope for trafo diif and 1 slope for busbar diff.3)what is the purpose of metrosil and stabilizing resistor in high impedance relay circuit.4)how metrosil reduce the peak volage.5)what is the funtion of stabilizing resistor
what is acceptance test in electrical engineering.
Could the power factor on electrical system can affect the registration of the kwhr meter or the CT/PT?
how can i change the rotation of the AC single phase induction motor and show me by diagram
I Need standard operation procedure(SOP)for 500kva Oil type transformer oil filtration & Procedure for IR value checking.
what's producer of XLPE cable laying in undergroung
Electronic circuit
Both generator parallel condition shared load equally but one genrator taking ampere more than the other what are all the causes to make like this
how you configure motorvision relay (L&T make)from DCS
Is it possible to protect 3phase overload and earth fault of the 3phase system using two CT's.
How much kv gas generator is needed to run 2 hp and 1 hp airconditioners, plus a refrigerator and 4 Tvs
