in VFD when freq is reduce the voltage will reduceor not if
it will reduced upto ...
- 8 Answers
- 8329 Views
- I also Faced
- E-Mail Answers
Answer Posted / arvind
Dear Amrinder
we know through v/f ratio, if frequency will reduce that
means the voltage will increase.
| Is This Answer Correct ? | 1 Yes | 1 No |
Post New Answer View All Answers
how we calculate the withstansing current capacity of wires&cables?
Define what is difference between fuse and breaker?
In Air circuit breaker LSIG protection unit is used. Without fault in cables (2 runs 3Cx150Sq.mm Copper, 1Kv grade, XPLE armored cable IR value is more than 550Mohm @ 500V Megger) and load section Long time Overcurrent protection is triggers and trips the unit. We changed LSIG protection with new factory tested unit. Even then fault is persisting. Please suggest the possible causes
What is the working principle of CFL & T5 tube light & 40W tube light with electronic ballast?
Why induction motor is widely used in industry
Hello sir i m student of gtu .what is idp.
what is the step by step formula for calculating bus bar phase and neutral size of a panel board.suppose the incomer of panel board is 100A..???step by step answer please
why we use condenser in the thermal power plant, althrough the same vapour will be again heated
The windings of a transformer are divided into several coils, because?
please send me jindal previous aptitude and technical question and answer.my email id is deep_raj@live.com
How to control motor gearbox speed and friquency? If length of cable and dia given, how to measure the voltage drop?
In india, according to trade theory above 5 HP motor reqired star delta starter. But we R connect 11 KV motor with 14MW in Direct to line ( With VCB starter combination) Can U Guess, How it is possible ?????
H.t motor 6600 volt to same motor lt supply 440volt supply applyed to h.t motor to effect....
How can you sized or estimate the ligthning arrester current rating?
hi this is hema can anyone mail me previous years questions for the APPSC-A.E.E (in electrical stream.) ......thank u.
