d/p flow transmitter LP side give to pressure.what you
geting out put ? how you get(ma)?
- 6 Answers
- 11882 Views
- ABB, I also Faced
- E-Mail Answers
Answer Posted / shivu
yahh for DP-transmitter we will be having the two taps at
the side or at the bottom side ,but to know the working of
the transmitter or for the calibration purpose we have
give/apply the pressure at LP-side tapping & the HP-side it
should be kept open for the atmosphere ,,,,,,,,,hence by the
difference of the pressure we will get the MA-output.,,i,e
with respect to the applied pressure
| Is This Answer Correct ? | 2 Yes | 10 No |
Post New Answer View All Answers
What is instrumentation technologists and mechanics?
what is maxdna ?. explain about the software details.
2. What is ultrasonic flowmeter?
i have used level transmitter in starch cooking preparation tank. tank total height 2mtr.sometime LT display shows some error value when tank is fully empty and diaphragm side i already checked okay no problem in diaphragm area. field cable checked 24volt and mA shows correct value while tank empty mA is 4mA. 4mA i needed that 0% but display showing 10% or 15% percentage values are varying continously please give any good solution for me.....
Make Heater Process Logic.
In Safe Guarding test what means by "Failed to Danger" ?
Sir, I am working as a Instrument Engineer in Grasim Industries. Can any body provide question answer for interview purpose
Calibration procedure for Electro magnetic Flow meter
Describe the functions of the Operator Interface including the considerations related to alarming and display layout/configuration/layers.
How to check vortex flow meter is in good condition while we do not having calibration setup?
I was working on calibrating turbidity transmitters endress+hauser at effluent polishing plant.We calibrated using NTU buffers.What happened is that when we immersed the sensor, everytime we raise and lower the sensor gradually, the reading will vary.my question is that is there any specifications on what is the required distance from the bottom of the container with buffer to the face of the sensor?Is it ok to install the sensor in a medium which has turbulence specially if bubbles are present?
how to connect transmitter measuring sulfur process? 1-by using long impulse line or 2- by using coated short impulse line
Can please tell mi about SIOS, PRM, SERVER, and what is the diference between PIN LAN, PCS LAN,APC Server, and please send the Doc if possible for referance,mail id patil_amit17@yahoo.com
Explain the key components of control loop?
Where are oxygen analysers installed in cfbc boilers? What are their usual readings?
