Golgappa.net | Golgappa.org | BagIndia.net | BodyIndia.Com | CabIndia.net | CarsBikes.net | CarsBikes.org | CashIndia.net | ConsumerIndia.net | CookingIndia.net | DataIndia.net | DealIndia.net | EmailIndia.net | FirstTablet.com | FirstTourist.com | ForsaleIndia.net | IndiaBody.Com | IndiaCab.net | IndiaCash.net | IndiaModel.net | KidForum.net | OfficeIndia.net | PaysIndia.com | RestaurantIndia.net | RestaurantsIndia.net | SaleForum.net | SellForum.net | SoldIndia.com | StarIndia.net | TomatoCab.com | TomatoCabs.com | TownIndia.com
Interested to Buy Any Domain ? << Click Here >> for more details...

in instrumentation why we are using 4-20mA , why not
voltage ? if somebody design a instrument which works on
voltage then can we use that instrument?

Answer Posted / himanshu

4-20 mamps is best choice because interference level is
minimum in current application where as in 0-10 V it is
comparatively high.Thus in using 4-20 mamps signal is
distortionless.

Is This Answer Correct ?    6 Yes 1 No



Post New Answer       View All Answers


Please Help Members By Posting Answers For Below Questions

how to calibrate corollaries (Mass flow meter)?

2171


What is difference between differential pressure & delta pressure?

1094


why we are using magnet for calibration of gas detector?

2251


In control valve proximity inductive sensor is taken as digital feedback for full open and full close.Normally its volts 24v when the sensor acts the feed back voltage 14v so that our relay not indicating in plc panel . kindly give the solution.

1970


HOW TO CALCULATE ACCURACY OF AN INSTRUMENT. WHICH IS COMPITABLE FOR USE.

2303


Instrumentation symbols interpration, P& ID, Logic diagram analysis, Electrical drawing analysis.

1958


Why is the orifice tab provided?

1219


What is the reason PT speed not incresed in gas turbine?

2407


why use 50% lel methane gas concentration for gas detector calibration instead of 60% lel gas concentration whereas the hi alarm set at 60% lel.

2734


What is the use of each wire in three wire RTD

2506


Make a ladder diagram on LSL valve will close, on PSL valve will open and start the motor

2141


how to convert cubic metre per hour to newton cubic metre per hour

2006


-/5A. What is the meaning and limitations of this in energy meter constant. It is a 3 phase LT Energy Meter. If this Energy Meter is connected through a CT of ratio 200/5 Amps, then what is the multiplying constant and how its will be calculated.

2455


can you send remote seal interface level transmitter calculation steps for oil water saperator.

2623


Definition of reverse and acting controllers:

2323