Interested to Buy Any Domain ? << Click Here >> for more details...
why the flooring of substation is done with small pebbles or
stones..?
- 16 Answers
- 42792 Views
- I also Faced
- E-Mail Answers
Answer Posted / d k sharma
there are two terms defined regarding floor of earthing system
1. touch potential(pot b/w hand and structurals (gnd) when a person is touching a grounded body like structurals in switchyard
2. step potential(pot diff b/w the feet of a person walking in the switchyard)
now to minimize these potentials we put pebbles in place of flat flooring.
the reptiles,moisture etc. are secondary reasons...
| Is This Answer Correct ? | 18 Yes | 3 No |
Post New Answer View All Answers
A powerplant has 8 gensets operating in grid parallel mode. In one genset sometimes there is pf variation and kvar variation. The plant operates in pf mode. When this variation is observed the load is stable, voltage is also stable, freq and genset speed is also stable. How will you check the functioning of pf card. What shall be the ideal output vdc of the pfc, from there it is input to AVR?
What are the types of windings present in the ceiling fan? What winding will be effective first when we started the fan?What are the resistance and inductance ratios comparatively at the initial speed and full speed of the fan?
why incomer bay is required before transformer bay if there are more than 1 nos. of transformer bay.
How do we calculate the Out put voltage of generator, after the excitation is being given?
What is the function of a neutral reactor.
Could Please Explain briefly. Why used stabilizing resistance series with High impedance bus differential protection relay.
what is distribution board?
What is force on a conductor in a magnetic field ?
why should the primary of transformer be connected in delta in a heat run test?
Which type of air compressor is used now a days in the market. Keeping in mind of energy efficiency and maintenance points. Relevant documents may also be sent on mentioned email ids.
how many parameters can integrate with fire alarm basically ?
You are of electrical field and you are going for software? Why
how much value of resistance should connect to 15 kw, 6 pole 3 phase slip ring induction motor having RV-240, RA-42.
Damping resistor provided in open delta (tartiary) winding of a measuring PT at the incoming of a MV inverter drive panel is getting heated up. Can any body explain the reasons and suggest the remedy?
in 132kv substation CRT means
