Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / jai prakash narain singh
MCCB-moulded case circuit breaker.mccb has protection for
over current,which can be set by turning the current
setting knob and you can also set the delay time.in case
over current occur for more than set time,it will trip the
mccb ,to protect the ckt
| Is This Answer Correct ? | 5 Yes | 2 No |
Post New Answer View All Answers
how to select diiferent power transformers of same capacity on no load loss and full load loss by economical point of view.?
How to check the cable fault / hv test of transformer cable.
what is the transmission loss for electrical supply? specifically a large shopping complex where the grid is half KM away, what will the % of transmission loss? is there any transmission loss for captive unit generation for above set? thanks
What type of a DC motor would you use for a lift?
bus bar design conditions and sizing pls tell me quickly
How to arrange a hous hold earthing system to keep minimum earth resistance( below 7ohms).
what is conductor constant of raccun conductor
why we use two slope(differential & restraining) in differential relay.but in busbar protection differential we are using only one slope?please explain
11 kg trivevter meter has rating of -/5amps. And pt ratio11000/110v and is connected with 11kv ct/pt unit of cr ratio 75/5amps. And pt ratio of 11000/110v while checking accuracy of meter with HT Accuchek meter what value of PT ratio and CT ratio to be filled in Accuchek meter
can anyone give an idea about dia calculation in cold rolling mill
if we give 60 hz single phase supply to the transformer used in europe , than what will happen
How to check 11000/1.732 to 110/1.732 Potentila transformer (PT)?
1sq mm dc powr cable can carry how much dc currnt
what is EIB lighting control system? what is the advantages of this system?
Why armature rheostat is kept in maximum position?
