if two bulb of 50w &30w apply in series having 230v the
which bulb glow bright ,why
Answer Posted / ahir
AS we know for series ckt p=i^2/r...
so, in which buld have low resistance will blow more.....
and 50W BULB have less r..
so , it blow brightly....
Is This Answer Correct ? | 6 Yes | 6 No |
Post New Answer View All Answers
Why 1/3 is used in symmetrical components?
3phase cable calculation formula by motor load
1.25 kg of hydrogen are burnt with stiochiometric air, the mass of air in kg required is
Is there a possibility to use such a treshold voltage for the NMOS part of a CMOS circuit that during the switching it will start conducting only after the PMOS part will be already closed, by this eliminating the leakedge current? Please note, I'm not asking about the well bias in standby mode, but about the "antileakedge" measures during normal operation.
how to calculate the cable current ratingand and how much of distance the rating will be ok will the distance is incresed what the action we take
How do you calculate the actual power consumption of an inductive load appliance. Say, a deep freezer of 200watts
What is clock position of Transformer?what are the clock positions are there?and what is different of them?
If ROC does not lies inside unit circle,then ? a) Fourier transform converges b) Z transform converges c) Hatly transform converges d) Colpit Transform converges.
When a single pase capacitor run motor- run on 230vac and Case(1)run with 8 Mfd 250 vac.capacitor , Case( 2) run with 8 Mfd 400vac capacitor. What is difference between both case regarding power ,efficiency etc?
diff b/w elcb and rccb
what is 3rd Harmonics? how it is generated in alternator
ANY ONE TELL ME ABOUT generator synchronization panel panel to synchronise 3 gen of 250kva both automatic and manual. 2 gen output vol 415 3ph, 1 gen output vol 400 3ph SEND THE DETAILS DIAGRAM ON THIS EMAIL ADDRESS ayazleo@hotmail.com as soon as possilble best ragrds electrical engineer ayaz mahmood SAUDI TECH
what would u consider to be the basic purchase order information you would need to proceed with a cable inspection assignment?
why they were using TRIAC instead relay in some controllers and what is the advantages.
what is plunger and what's the use of it in motor alignment?