Interested to Buy Any Domain ? << Click Here >> for more details...
Explain Split Range Control In Control Valve Briefly.
- 5 Answers
- 30424 Views
- I also Faced
- E-Mail Answers
Answer Posted / arunnatraj
split range control is which the output of a controller is
split to two or more control valves. For eg,
For 0% controller output,valve A fully open & B fully
closed.
For 25%, Valve A 75% open,B 25% open
For 50%, Valve A& B- 50% open,
For 75%, Valve A 25%open, B-75%open..
For 100%, Valve A fully closed & valve B Fully Open..
Like this, d controller output action can be set depending
upon the application...
| Is This Answer Correct ? | 22 Yes | 17 No |
Post New Answer View All Answers
How to calibrate radar type level transmitter for interface level? Total liquid(liq.1 and liq.2), level both the liq individually? For. Both the liquid levels how the signal will go from transmitter to dcs? How to calibrate. Single radar 9:26:55 AM for 2 different liquids in a tank?
How can we test a bently nevda 3500/42M accelerometer monitor card by simulating it with test equipment?. what king od of signal (milli volts or volts or or resistance ) we should feed in the terminals of the card?
How INtools is useful for routine Instrument maintenance?
Is there any relation between Artificial Intelligence and Instrumentation?
which type inter lock use in petrochemical refinery,and oil & gas?
how to calibrate 0- 150 psi presure gauge by dead weght tester
What is the cascade control
can any one tell me when ongc placement test and its forms is available????/ pls tell me if u know
What happen if we install my pressure transmitter below the elevation of pipe in natural gas service?
why we take %i0.0 as input for twido plc
Good evening all I need a small favour regarding reliance paper i wanna probable sample papers(e&i) of reliance. if any of u have any idea about dis then plz mail me back.i belongs to electronics and instrumentation engg.so i need e&i papers. thanking u....
Why trim span ? How?
how to work MIL contol valve posistioner ?
Q- Control problem are mainly classified in _____ types. a-)4 b-)3 c-)6 d-)nono of these Few of them i know is 1- regulator type problem (eg- Air conditioner) 2- tracking problem (eg missile trcking problem) 3- sybernatics 4- optimal control problem
Basically iam Instruemntation Engineer, but Iam interested in Instruments design engineering, so plz guide, is there any course, training or Softwres to become Instrument design engineer??.
