Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / jj
by using HART communicator
| Is This Answer Correct ? | 5 Yes | 12 No |
Post New Answer View All Answers
how pressurize drum calibrated ?
what is the electrical operation procedure for switching on 27.6MVA electric furnace.
how u calibrate sox nox co2 co in cemps?what is opacity n HPm?tell the standard parameters of cems?
for oil & gas industries which zone is normally preferred? why? give its example?
what is function of switch, and how is it work, explain with difination
What is the use of each wire in three wire RTD
A DP transmitter is used to measure the level of an open tank. The drain line of the tank is connected to a control valve, and is configured as, if the level of the tank is 90% the valve should get open 10%. And if the tank level is 10%, the valve should get open 90%. Draw wiring diagram and explain how to configure DP transmitter and control valve using HART communicator. If the span error at output is 1%, what will be the %opening of the control valve at 60% level of the tank?
Explain why plc require in analog input 4-20amp & 0-10 volt?
WHY THE DEGREE OF VALVE PLUG AND VALVE SEAT IS SLIGTLY DIFFERENT I CONTROL VALVE TRIM DESIGN
Where Can i take a SPI INtools training in Mumbai? In Rolta India Ltd to whom I should approach regarding of SPI INtools Training?
what is the difference between scaler and vector drive
what is the advantage of submersible level transmitter compare to ultrasonic level transmitter?
how can be calibrate flow indication transmitter (rosemount) it shows excess milli amps nearly about 24 ma on full scale, but its scale was set on 20ma on full scale..???how can be simiulate..???
in differential pressure transmitter,min&max pressure range for hp&lp
can u plz send me technical questions asked in SCHNEIDER ELECTRICAL technical paper?
