Answer Posted / sandhya
using form factor we can calculate heat load
| Is This Answer Correct ? | 2 Yes | 1 No |
Post New Answer View All Answers
Can any body tell me the different types of LT cables & their application.
do any one help me to get "C" license,, i have doubts ,,, if mediators ter pls call me,, my no is 8056640042
how does commutator convert a.c to d.c?
What is the difference b/w fanuc alpha series 16i and 18i controller. what is stand for i
application s to shunt coil
how to calculate sizing of NGTR (Transformer rating,Loading resistor value and Current rating of resistor) and what is the X/R ratio. Details : 11kV,Capacitance 1.73532 micro farads,40kA for 1sec.
why single CT used in DOL starter power circuit?
what happen if generator of micro hydro running at only a small percentage of its capacity, as a comparison, if the diesel generator that runs on only a fraction of its capacity there will be a wet stacking
during installation time of transformer and alternator which points we have to observed?
in an electronic tri vector meter when the current and voltage sequence changes ? what is the effect of phase sequence on recording of meter
what is mean by NPS (Negative phase sequence)fault? what is the difference between EFR & OCR faults?
What is the cut-off rate?
Define what is difference between fuse and breaker?
why motor range is available 22kv,30kv,37kv,45kv and so on? why motor range is not available 21kv,24,25,26,27kv and so on?
The gauge indicates the number of amps, but what about voltage? How voltage rating (for wire or fuse) determined?
