Interested to Buy Any Domain ? << Click Here >> for more details...
WHAT IS A CALLIBRATION? WHAT IS MEEAN BY LOOP CHECKING
INCLUDES PRESURE, THERMOCOUPLE,TT,DT?
- 5 Answers
- 11041 Views
- I also Faced
- E-Mail Answers
Answer Posted / kaja farkhan
Calibration is nothing but comparisonof an unknown standard
with an known standard or in other words it is known as
checking the output is proportional to the input or not.
Loop checking is nothing but the instrument installed in
the field must give the signal to the control room without
any break. First in this the continuity of the cable will
be checked from inst to JB in field side and from the JB to
control room.
| Is This Answer Correct ? | 15 Yes | 3 No |
Post New Answer View All Answers
how to turbine speed measurement?
is motorized valve closed when power shutoff?
Sir,I am going to sit for IOCL written test exam. recently.Can anyone tell me the name of 'Objective type Question Book on Instrumentation Engineering ' which will help me. Pl. mail to bidyut_71@rediffmail.com / bidyut.saha2008@indiatimes.com / bidyut.saha09@yahoo.in
1. what is modbus cable? 2. what kind of communication we are using for the interface of DCS, ESD and Third party cabinets? 3. What is serial communication and peer to peer communication?
how is work pressure switch& level switch?what is the principle of this?
what is the usage of QDV & VOLUME BOOSTER
What is difference between “Fault Tolerant” & “Fault avoidance” PLC? Application where these system s are used?
In VVVF DRIVES VOLTAGE IS ALSO VARY WITH THE FREQUENCY. HOW? WHAT IS THE DIRECT FORMULA RELATING THESE TWO.
If a warning lamp will operate with the ground circuit is bypassed with a jumper wire to ground, what should you check?
Please send me the sample question of Instrumentation of hpcl/iocl exam. my mail id hihi_kiholo@rediffmail.com
how u choose thermowell lenght n pnumatic C/v size?
TEMPERATURE VARIATION FOR FREQUENTLY.
what is the process to make control schematic ?
Why humidity limit is 30 to 55 % for raw material storage?
why we are using digital signals for I/O & how to measure this signals is getting or not ?
