if we supply DC power to AC transformer then what its result?
Answer Posted / elumalai
transfomer primary winding burn and there is no mutul
inductance emf
| Is This Answer Correct ? | 3 Yes | 1 No |
Post New Answer View All Answers
how to determine ct ratio in ht vcb?
what is the use of permanent magnet generator in exciter
In constant power region of 3-phase IM torque-speed characteristics, if frequency increases slip A does not alter B decreases C increases D none of above
15hp motor wound by 0.9mm & 0.95mm magnet wire. at no load test it draw 4.2A current. Another motor with same condition draw 9.2A current. How can that occur? pls help
Is there a possibility to use such a treshold voltage for the NMOS part of a CMOS circuit that during the switching it will start conducting only after the PMOS part will be already closed, by this eliminating the leakedge current? Please note, I'm not asking about the well bias in standby mode, but about the "antileakedge" measures during normal operation.
why ups rating in kva? and why ups are in parellel?.why isolation transformer is used in ups?
what is acceptable leakage current for 33kv cable while doing high voltage test for cable? how to calaulate the leakage current for 33kv or any rated cable?
after how many spot we must chang secondry cable in portable spot welding gun?
Why does increasing the magnetic flux in the main field of a d.c motor cause the armature current to reduce??
What is difference between slip rings and carbon burushes?
If we use 250A MCCB as a incomer in Control panel for a fault level of 50kA for one second ,assuming temperature rise from 85 Deg. to 100 Deg , Then what will be the Aluminium Bus-bar size for 250A MCCB? Explain in detail.
what is the best transformer oil breakdown voltage?
What is an Air COmpressor
what will be the maximum winding temperature of 6.6kv HT motor 450kw, Full load current 49A. 50Hz Frequency.
how can calculate resistance box for 15 kw, 6 pole, RV-230, RA-42 motor